RAMSET R150 Manuel d'utilisateur télécharger pdf (Page 9)

QUICK CHANGE NOSE

The R150 tool is equipped with a quick

change nose. This feature allows the user

to change the work contact element to

meet various fastening needs. The work

contact element can be changed without

the use of tools by following these steps:

Removal

1.

Remove battery from the tool !!!

2. Firmly grasp the end of the Work

Contact Element and turn it 90 degrees

3. Pull the Work Contact Element from

the tool.

Replace

1. Orient the Work Contact Element

so that the notched or flat portion is

toward the back or the tool

2. Firmly push the Work Contact Element

up into the nose piece.

3. Slightly twist the Work Contact Element

to be sure it is fully engaged in the nose.

NOTE: There should be no open gap

between the shear block plate and the

nose piece.

4. Insert the battery and operate the tool.

Work Contact Elements

P/N: M150200 – To be used with fasteners

with pre-mounted 1/2" washers.

P/N: E150100 – To be used with straight

pins, fasteners with eyelets, and fastener

assemblies.

QUICK CHANGE NOSE

QUICK CHANGE NOSE

9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire