RAMSET R150 Manuel d'utilisateur télécharger pdf (Page 3)

Preparation For Fastening

Acceptable Base Materials

The gas powered R150 tool is

suitable for use in the following base

materials only:

• Poured Concrete

• Structural Steel

• Concrete Block and Horizontal Joints

in Brick or Masonry Walls

Never attempt to fasten into any other

type of material.

Fastening into other

materials can cause blindness or other

serious injury.

Never attempt to fasten into very hard

or brittle materials such as cast iron,

tile, glass, or rock of any type.

These

materials can shatter, causing the fastener

and/or base material fragments to fly

free and cause serious injury to the tool

operator and others.

Never fasten into any base material that

does not pass the Center Punch test.

Failure to assure the suitability of the

base material can result in serious injury

to the eyes or other body parts.

Center Punch Test

ALWAYS WEAR SAFETY GOGGLES

WHEN PERFORMING THIS TEST.

1. Always check the material being

fastened into for hardness before

attempting any fastening operation.

2. Using a fastener as a center punch,

strike the fastener against the work

surface using an average hammer

blow and check the results.

Center Punch Test Results

1. If the fastener point is flattened,

the material is too hard for a

powder actuated fastening.

2. If the fastener penetrates the material

easily, the material is too soft.

3. If the material cracks or shatters,

the material is too brittle.

4. If the fastener makes a small

indentation into the material, the

material is suitable for fastening.

Structural Steel

Solid or Hollow

Block

Horizontal Joints

only in Brick Walls

Solid Concrete and

Precast Concrete

SAFETY INSTRUCTIONS

DANGER 3

DANGER

SAFETY INSTRUCTIONS

1 2 3 4 5 6 7 8 ... 15 16

Commentaires sur ces manuels

Pas de commentaire