RAMSET D60 Instructions d'exploitation télécharger pdf (Page 16)

DISASSEMBLY

16

DISASSEMBLY

TOOL DISASSEMBLY

1. Slide the barrel assembly out of the

tool until the barrel shroud clip is

exposed.

2. Unscrew and remove the pawl

assembly. Note the position of the

notch on the pawl as the pawl is

removed. The pawl must be installed

at reassembly with the notch in this

direction.

3. Slide the barrel assembly completely

out of the tool body. Note the position

of the ball bearing retainer with the slot

in the top of the receiver for reassembly.

4. Remove the barrel shroud clip using a

flat screwdriver or long fastener. Take

care when removing to be sure the clip

does not fly away when freed from the

outer barrel.

SLIDE THE BARREL ASSEMBLY OUT OF

THE TOOL TO EXPOSE THE CLIP

REMOVE THE PAWL ASSEMBLY

REMOVE THE BARREL SHROUD CLIP

SLIDE THE BARREL ASSEMBLY OUT OF

THE TOOL BODY

Shroud Clip

Notch

1 2 ... 11 12 13 14 15 16 17 18

Commentaires sur ces manuels

Pas de commentaire