RAMSET XT540 Instructions d'exploitation

XT540 TOOLOPERATOR’S SAFETY & OPERATING INSTRUCTION MANUALDANGERTHIS TOOL FOR USE BY LICENSED OPERATORS ONLY.READ AND OBEY ALL SAFETY AND OPERATIN

2. Insert the power load. With the tool in the closed position insert a power load strip into the cavity in the base of the rubber handle and push

TROUBLESHOOTING TROUBLESHOOTING11Most commonly, problems are caused by over driving due to poor fastener or charge selection. It is wise

PARTS SCHEMATICPARTS SCHEMATIC 12XT540

PARTS LIST / MAINTENANCE PARTS LIST / MAINTENANCE13Always make sure the tool is not loaded before performing any service or repair

INSPECTION / TOOL MAINTENANCE 14INSPECTION / TOOL MAINTENANCE1. Ensure that no power loads are loaded in the tool. Remove the power load strip by pul

INSPECTION / TOOL MAINTENANCE15INSPECTION / TOOL MAINTENANCE Re-assembly is the reverse of disasssembly1. Position the barrel’s groove

XT540 WARRANTY AND LIMITATIONSPOWDER ACTUATED TOOLMANUFACTURERS' INSTITUTE INC.TMConcrete Fastening SystemsGlendale Heights, IL 60139 800-RAMSET6

Just as no one can merely read a book about driving an automobile and then hope to drive one safely, no one should attempt to use any Ramset tool wi

PreparationAcceptable Base MaterialsPowder actuated fastening is suitable for use in the following base materials only:• PouredConcrete• Structural

Loads & Load Selection Safety1. Always make a test fastening after being sure that the base material is suitable for powder actuated fastening

Tool Handling Safety1. Always be sure tool is operating properly before attempting to use it. Follow the “Daily Function Test” shown to the right an

FAILURE TO FOLLOW INSTRUCTIONS CAN CAUSE INJURY TO THE TOOL OPERATOR OR TO BYSTANDERS.Fastener Driving Safety1. Only use the tool for fastening into

FASTENERS / LOADS FASTENERS / LOADS 7Your Ramset XT540 Tool uses only the Ramset fasteners and loads shown below or listed for the too

FASTENING APPLICATIONSYour Ramset tool can be used for a wide range of fastening needs in a variety of base materials. Reading and follow these impor

TOOL OPERATIONDAILY FUNCTION TEST Always check the tool first to make sure that it does not contain a strip load or fastener. Test the tool several t