RAMSET Cobra Tool Instructions d'exploitation Page 10
- Page / 16
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
4. Hold the tool perpendicular (90°) to
the work surface with both hands and
press firmly to fully depress the tool.
Maintain firm downward pressure on
the tool with both hands and pull the
trigger to drive the fastener. DO NOT
DEPRESS THE TOOL AGAINST ANY-
THING OTHER THAN THE INTENDED
WORK SURFACE. Holding the tool firmly
in place will produce more consistent
fastening quality and minimize tool
wear or damage.
5. After making the fastening, fully open
and then close the tool to the semi-
closed position. This resets the piston
and indexes a new load into place for
the next fastening.
6. Insert another fastener in the muzzle
end of the tool as before and the tool
is ready for the next fastening. Keep
your finger off of the trigger until the
tool is in position to drive the fastener.
7. To remove a used or partially used
strip load from the tool, pull the strip
out from the top of the tool. Do not try
to remove the strip by pulling it out from
the bottom of the handle. NEVER
try to remove a jammed or stuck
load strip. Should a “jammed” load
strip occur, call your local Authorized
Ramset Distributor for technical
assistance.
TOOL OPERATING INSTRUCTIONS
TOOL OPERATING INSTRUCTIONS
10
HOLD THE TOOL FIRMLY
AND PERPENDICULAR TO THE
WORK SURFACE
FULLY OPEN THE TOOL AND THEN CLOSE
IT TO THE SEMI-CLOSED POSITION
INSERT THE NEXT FASTENER
REMOVE THE LOAD STRIP ONLY FROM
THE TOP OF THE TOOL
90°
KEEP HANDS
AWAY FROM
MUZZZLE
- COBRA TOOL 1
- Center Punch Test Results 3
- Acceptable Base Materials 3
- Unacceptable Base Materials 3
- SAFETY INSTRUCTIONS 4
- DANGER 5 5
- Fastener Driving Safety 6
- ALWAYS FOLLOW THE 6
- MISFIRE PROCEDURE 6
- 3" MIN 8
- 1/2" 8
- 1-1/2" 8
- TOOL OPERATING INSTRUCTIONS 10
- TROUBLESHOOTING 11
- PARTS SCHEMATIC 12
- PARTS LIST / MAINTENANCE 13
- DISASSEMBLY 14
- WARRANTY 16
Produits connexes et manuels pour Outils électriques RAMSET Cobra Tool
(16 pages)AixConcept KE3-NCOO-TIMER manuály
Uživatelské manuály a uživatelské příručky pro Doplňky pro regály AixConcept KE3-NCOO-TIMER.
Poskytujeme 1 manuály pdf AixConcept KE3-NCOO-TIMER ke stažení zdarma podle typů dokumentů: Datový list
Commentaires sur ces manuels