RAMSET RAM 1000 Instructions d'exploitation

RAMSET MODEL TF1100 TrakFastOPERATOR’S SAFETY & OPERATING INSTRUCTION MANUALDANGERREAD AND OBEY ALL SAFETY AND OPERATINGINSTRUCTIONS BEFORE OPERAT

FUEL CELL AND METERING VALVE FUEL CELL AND METERING VALVE 10INSERTING FUEL CELLWith the Metering Valve Stem pointed toward the front of the tool, in

FASTENERS The TrakFast tool can drive only Ramset fasteners which have been collated into strips. Any other fastener will cause tool damage and void

SERVICINGSERVICING 12Field service should be restricted to the following: qCHECKING THE ENERGY LEVEL OF THE BATTERY qRECHARGING THE BATTERY qCHEC

SERVICING13SERVICINGCLEARING A JAM (continued) At this point, the jammed fastener should fall out. If the jammed fastener does not fall out, carefully

TROUBLESHOOTING 14TROUBLESHOOTIN GSYMPTOM POSSIBLE PROBLEMS SERVICEPreparing Tool for Operation—Battery/Charger Problems

TROUBLESHOOTINGTROUBLESHOOTING15SYMPTOM POSSIBLE PROBLEMS SERVICEPre-Combustion/Combustion Stage of Operation P

TROUBLESHOOTING 16TROUBLESHOOTINGSYMPTOM POSSIBLE PROBLEMS SERVICEReturning/Purging Stage of Operation If the TrakFas

Ramset warrants that new TrakFast systems power fastening tools, parts and accessories will be free from defects in material and workmanship for the

FOR TOOL REPAIR SERVICE CONTACT YOUR LOCAL AUTHORIZED RAMSET DISTRIBUTOR OR TO FIND YOUR NEAREST RAMSET TOOL REPAIR CENTER VISIT OUR WEB SITE AT WWW

Introduction ... 2An Overview of the TrakFast Tool ...

DESCRIPTION The TrakFast tool is a self-contained, fully portable tool that uses liquid hydrocarbon fuel to power a unique linear drive internal combu

SAFETY INSTRUCTIONSSAFETY INSTRUCTIONS 4The following safety instructions have been included in this manual to provide you with basic information nece

5. NEVER CARRY THE TOOL WITH YOUR FINGER ON, OR DEPRESSING, THE TRIGGER. You must remember that the TrakFast tool operates in a specific sequence. T

15. ALWAYS FOLLOW MINIMUM FASTENER EDGE DISTANCE AND SPACING REQUIREMENTS. The minimum edge distance and spacing requirement for concrete base materia

BATTERY CELL AND CHARGER The first step in preparing a new tool for operation is to fully charge the new Battery. New Batteries are shipped discharged

THE BATTERY AND CHARGING SYSTEMTHE BATTERY AND CHARGING SYSTEM8INSERTING BATTERY 1. Load the Battery, contacts first, into the TrakFast tool.2. Lock

FUEL CELL AND METERING VALVE9 FUEL CELL AND METERING VALVEFuel Cell DANGER EXPLOSION/FIRE HAZARD Read ALL safety instructions before u